What To Do If Your Water Heater All Of A Sudden Stops Working

Book An Appointment

The author is making several good observations on Hot Water Heater Repair overall in the article down below.


No Hot Water — Water Heater Repair
Several contemporary homes make use of an electrical hot water heater for their heating unit, because of its convenience and convenience of use. Nevertheless, much like any other electrical devices, troubles may occur with its usage, all of a sudden. It can be actually discouraging to get up to a cold shower as opposed to a warm one or having your bath with water that isn't hot adequate or perhaps as well hot. Whatever the instance might be, water heater problems can be fairly stressful. Fortunately, we have actually made a checklist of possible remedies to your hot water heater issues. There are a number of elements that could create much of these issues, it could be an issue with the power supply, the electric burner, or the thermostat. Before doing anything, ensure you switch off the major power supply for security. Whatever the problem is, getting it dealt with must not position too much of a concern if you comply with these steps:

Check Your Power Supply:


As standard as this may seem, it is really needed. Without sufficient power, your hot water heater will certainly not work. So the first thing to do when your water suddenly retires is to verify that it isn't a power problem. Examine if the fuse is blown out or the circuit breaker stumbled. If the circuit breaker is the concern, just turn it on and off once again. Replace any kind of damaged or damaged fuse. Check the appliance with power after these adjustments to see if it's now functioning.

Inspect the Burner in the Hot Water Heater:


If it's not a power problem, after that try looking into your heating element if it is still functioning. Evaluate each of your heating elements to be sure the trouble isn't with any of them. If any one of them is defective, change that part and afterwards check whether the warm water is back on.

Check Your Thermostat:


If your hot water heater still isn't working or the water appearing isn't hot sufficient, you might need to examine the temperature setups on your upper thermostat. Make certain the circuit breaker is turned off before doing anything. Open up the access panel as well as press the red switch for temperature reset over the thermostat. This should assist heat the water. Turn the breaker back on and examine if the problem has been resolved.

Call An Expert:


If after changing all faulty parts and also resetting your temperature, the hot water heater still isn't functioning, you may require to speak to an expert plumber for an expert point of view. The problem with your heating unit could be that the cold and hot faucets have been changed or it might be undersized for the amount of hot water required in your house. Whatever the case may be, a specialist plumber would help fix the issue.

Verdict


Hot water heater problems are not always significant. Most of them are due to minor concerns like a blown fuse or damaged heating element. Replacing the malfunctioning components need to do the trick. Nevertheless, if you are still not able to address the trouble, give a call to your nearest plumber to find to get it taken care of.

8 possible reasons why you have no Hot Water


Along with streaming Netflix and having light flood a room when we flick a switch, having hot water flow from our taps and showerheads whenever we want is an oft-overlooked modern miracle of homeownership. That's why, when that flow goes cold, it can be shocking — and not just in a "Wow, that's freezing" kind of way while you're in the shower.


Water Leak


Before hot water reaches your taps and showerheads, it needs to spend some time in your water heater. This appliance, which can be either gas- or electric-powered, takes the cold water that enters your home from your well or utility company and cooks it until it gets hot. It's akin to an electric tea kettle.



Obviously, if your water heater is leaking, it will never fill with water so it won't have anything to warm. To see if this is the case, simply examine the area around the water heater to see if it is wet. If so, you'll likely need to replace the unit, but you can also call in a pro for a second opinion and to see if it is fixable. Sometimes leaks can happen around fixtures on the water heater, and if so, the solution might be as simple as replacing them.


Gas Heater: Gas Leak


If your hot water is fueled by natural gas and there is a leak in the supply line or where the line enters the tank, the appliance won't have the power it needs to heat up your water. The result is not only inconvenient, but it can be extremely dangerous as well. If you smell gas when you investigate your water heater, call your gas utility company immediately and report it as an emergency. It might also be prudent to leave your home until a repair person from the company arrives. Your utility company will usually fix any kind of gas leak. However, in terms of getting your water heater working again, you'll need to relight the pilot and wait a while to see if it is functioning properly. You can call in a water heater specialist or plumber to help with this.


Gas Heater: Pilot Light Problems


There are two other issues with gas-powered water heaters that can lead to a loss of hot water. The first is a pilot light that's blown out. The pilot light is the source of a constant flame inside your water heater. When the heater determines the need to heat up the water it is holding, it will open a valve that will cause gas to flow over the pilot light and cause it to ignite. To see if your pilot light is functioning, there is usually a small window in the front of the water heater. If you can't see a flame, remove the access panel and see if that helps you locate it. If there is still no flame, you'll need to relight it in accordance with the manufacturer's instructions.



Your pilot light should burn with a bright blue flame. If not, make sure there are no drafts affecting it, which could keep it from functioning properly. If the flame looks yellow, it might be a sign of the presence of carbon monoxide, which spells trouble and needs to be looked at right away by a technician.


Gas Heater: Faulty Thermocouple


The second reason why a gas-powered water heater might fail is a faulty thermocouple. This is a small probe that should sit in the pilot light flame. Its purpose is to stop the flow of gas if it senses that the pilot light is out. Sometimes, these probes get knocked off track, so make sure it is directly in the flame. They can also get a buildup on them that prevents their function, so try cleaning yours off with some steel wool or fine-grit sandpaper. If your pilot light won't stay lit and you've tried these steps to fix the thermocouple, it is likely faulty and needs to be replaced. Call a technician.


Electric Heater: Breaker Blues


Electric water heaters don't have pilot lights, because there is no gas to burn in order to heat up the water. Instead, they do their magic through the use of (naturally) electricity. But that's not to say things can't go wrong with them. If your electric water heater isn't working properly, there's a good chance that a breaker was tripped that supplies the appliance power. Check your breaker box and flip any breakers that have switched to the off position back on. If it trips again, then there might be a fault in the water heater, and you'll want to call in a pro to have a look.


Electric Heater: Reaching The Limit


If the breaker is fine, check to see if the high-temperature limit has switched off on the water heater itself. To do so, first turn off the breaker to the unit. Then remove the service panel and press the red button you'll find there. This is the limit switch, and resetting it could solve your problem. To check, replace the panel, turn the breaker back on and listen to see if the water heater is functioning again.


Electric Heater: Heating Element


If these steps don't fix the issue, then you might have a failed heating element, which will need to be replaced. Unless you are comfortable with such repairs, calling in a technician might make the most sense.

https://www.homeserve.com/en-us/blog/home-improvement/no-water-heater/


What Would Cause My Electric Water Heater to Stop Working?

As a keen reader about How to Troubleshoot and Repair an Electric Water Heater, I assumed sharing that topic was worthwhile. Loved our posting? Please share it. Let somebody else find it. Thank you for your time spent reading it.




Schedule Your Service

Leave a Reply

Your email address will not be published. Required fields are marked *